At least if that was PLA (and not a Photoshop job) there’s be no risk of it failing mid-flight. Because it would rip to shreds the second torque was applied to it.
Funny joke, but before anyone assumes this is real and criticizes the print quality:
Both of these photos are edited from the picture on the Wikipedia page for the rotor retaining nut. The one on the right doesn’t even look like a real 3D printed part: the lines on the top surfaces aren’t parallel, in addition to it being incredibly messy overall.
I assumed the one on the right was greased and ready to use.
As someone who tests materials and parts like this for a living, I can look at that part and say with 100% certainty that it will last for a period of time.
Nanoseconds are technically a period of time, yes.
I think we can get a bigger number if we just measure in femtoseconds. And bigger number is better.
It’ll work for the rest of your life!
It’ll break before it gets of the ground.
Only if you’re otherwise unlucky, as you’re not leaving the ground
As a sacrificial cast right?
Yeah! But he’s the sacrifice.
No, lost casting could work. It should be thoroughly tested before relying on it for your life though.
I doubt they’re gonna be doing lost casting in high tensile steel.
Probably just gonna like melt down some aluminum soda cans and say it’s good enough.
They could with stainless, but you’re probably right.
Ig we just calling any rust at all “rusted out” now. Cool
Yeah that nut on the left is clearly still good.
That is the most awful 3d print I have seen in my entire life. And I have seen benchys printed my cheap prusa clones.
How did they even manage to finish the print with filament chunkier than a homeless persons cum and bipolar ahh nozzle temperature
I think it might actually be photoshopped to look like a print, because that’s the same picture that’s on the Wikipedia page for Jesus Nut, with the same hand, background, and shadows, except on Wikipedia it’s obviously a metal part. I spent way too long comparing them trying to figure out if they shopped a 3D print over the real one or colored and textured it to look like a print, and I think it’s the latter.
The supposedly rusted nut is also modified from the wiki page. My gut is telling me this is AI rather than Photoshop for both of these images
So it’s a quality meme? Nice
Good spot! The image is exactly the same apart from the nut (which is also exactly the same shape).
is uh…cum not supposed to be chunky?
Depends hov much you cook it
saved this comment so I can laugh again when I remeber to check saved
Oooo does it make one of those cool noises that squishy toys make?
It makes those terrifying noises that dying helicopter passengers make.
