A regular sized bagel is 60g of carbs, more or less. My dietician had me target 60-75 grams of carbs per meal with a total daily target of 225-245 for my type 2 diagnosis.

Franz was the Archduke of the Austro-Hungarian empire. You’re thinking of Gavrilo Princip.

Yeah but you’re arguing that to someone who already said they did buy. You can make that point but you’re directing at the person you’re responding to, who has already said they own a house. You are going to strain your shoulder.

Interest rates in the states are higher than they were five years ago, which means borrowing money to pay those inflated salaries is more expensive.

Apparently they didn’t. Top executives are both pissed at Bob Iger and scrambling to figure out how to right the ship.

I started getting this after I got diagnosed with diabetes, because I started eating way less junk food, so my salt intake went down. My blood pressure is usually on the low end now. It’s annoying, and I’ve talked to my doctor about it but she mostly said to drink more water.

You can do timed mutes of keywords, though the times aren’t as customizable as some people might like.

We’re on Metric time already, the base unit of measure for time in the Metric system is the second. This is decimal time.

It’s more likely that Connecticut comes alphabetically after Colorado in the list of state names and the number of data sets it used for training that were lists of states were probably abover the average, so the model has a higher statistical weight for putting connecticut after colorado if someone asks about a list of states

It’s funny seeing the list and knowing connecticut is only there because it’s alphabetically after colorado (in fact all four listed appear in that order alphabetically) because they probably scraped so many lists of states that the alphabetical order is the statistically most probable response in their corpus when any state name is listed.

Yeah but this whole post is about resin prints, which cannot be acetone smoothed.

No, the reason clear 3d prints are cloudy is because layer lines cause scattering, which makes it appear cloudy. Coating the surface with a clear epoxy fills in the tiny gaps that causes light to scatter, improving the optical clarity.

Is the part in the middle not 3D printed? It says Formlabs Form 3.

Yeah… Like, I agree a lot of the liberal “resistance” is useless but also every time I see a leftist online advocating for revolution, I’m wondering when they’re gonna kick it off.