I have one of these routers I attempted to upload firmware from the gui and now I cannot access it and no wifi networks show up.
I can access the serial console and attempted to run a TFTP server from my pc in order to re-flash but it just times out when I try to load the firmware from the server.
I have the IP of the server set to 0.0.0.0:69 when I try to set it to 10.10.10.3 (per the wiki) The server on my pc won’t start and gives an error. I know it’s probably a network setting that won’t let me set the correct ip address, just not sure where to go from here. Any help is appreciated.
You’ve got your network adapter set up to get an address from DHCP. If you need to host the server on 10.10.10.3, you need a network adapter set to that IP. the server can’t bind to 10.10.10.3 if no adapter is set to that IP.